Troubleshooting - Parkside PFMR 1600 B2 Instructions D'utilisation Et Consignes De Sécurité

We recommend using the original package
¾
for storage or covering the product with
a suitable cloth or enclosure to protect it
against dust .
˜ Transportation
Switch the product off and disconnect it from
¾
the mains .
Attach transportation guards, if applicable .
¾
Always carry the product by its gripping
¾
surface .
Protect the product from any heavy impact
¾
or strong vibrations which may occur during
transportation in vehicles .
Secure the product to prevent it from slipping
¾
or falling over .
˜ Troubleshooting
m
WARNING!
Only perform the steps described within
u
these instructions! All further inspection,
maintenance and repair work must be
performed by an authorised service centre
or a similarly qualified specialist if you
cannot solve the problem yourself!
Suspected malfunctions are often due to causes
that the users can fix themselves . Therefore check
the product using this section . In most cases the
problem can be solved quickly .
Problem Possible cause
Product Not connected to
does not power supply .
start .
Power cord or plug
is defective .
Other electrical
defect to the
product .
Product Power source
does not (e .g . generator) has
reach full too low voltage .
power .
Air vents are
blocked .
Unsatis- Accessory is worn .
factory
result .
Accessory not
suitable for intended
operation .
˜ Service
m
WARNING!
Have your product repaired at the service
u
centre or an electrician, using only original
manufacturer parts . This will maintain the
safety of this product .
If the supply cord or plug is damaged, it
u
must be replaced by the manufacturer, its
service agent or similarly qualified persons
in order to avoid a hazard .
Solution
Connect to
power supply .
Check by
a specialist
electrician .
Check by
a specialist
electrician .
Connect
to another
power source .
Clean the air
vents .
Replace with
a new one .
Use suitable
accessory .
GB/IE 31