Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Fig. 3
Pre-drill Dimensions: Pre-drilling with a 3/16"[4.5mm] drill bit is required
A*
34" [864mm] Panel
3-3/16" [81mm]
40" [1016mm] Panel
3-3/16" [81mm]
*Dimension A positions bottom edge of rail 3-3/4" [95.5mm] above deck surface.
*Dimension A is measured from the bottom surface of post base.
Fig. 4
CB-05 Angled
Bracket
Step 2:
Pre-drill Angle Bracket Holes
Tip:
• It's important to double check dimensions to confirm
accuracy of bracket hole locations before drilling.
1. Use Spring Punch to mark the holes. As shown in Fig. 1.
2. Pre-drill bracket holes with a 3/16" [4.5mm] drill bit.
As shown in Fig. 2 & 3.
3. Remove the bolt from the Angle Bracket Assembly.
Fig. 1
CB-05 Angled Bracket Hole Locations
30-1/2" [774.5mm]
36-3/8" [924mm]
C
B
A
C
PURE VIEW: Fe
GLASS BALUSTER INSTALLATION
26
B
C
Fig. 2
1"
[25.5mm]
C
2-1/2" [65mm]
2-1/2" [65mm]
A
Pre-Drill
with a 3/16"
[4.5mm]
drill bit
UB-05 Angle
Adapter
23
Publicité
Table des Matières
