Alecto DVC-105 Mode D'emploi page 26

5 RESET.
When contact with the camera is no longer possible and you can no longer
determine what the IP address or the port number no longer corresponds, you can
externally reset the camera to restore the default factory
settings.
At the rear of the camera you'll find a small hole marked
'reset'. Use a pointy object such as a paperclip to press
the button inside this hole.
Press this button while the camera is starting up and keep
it depressed for at least 10 seconds.
The camera can now only be reached via Wi-Fi Direct.
Now follow the registration process, see section 3.
6 TO INSERT THE SD CARD.
At the side you'll find a slot for inserting a Micro SD card,
this card slot sits rather deep. You might have to use a
paperclip to carefully press the card until it clicks into the
correct position.
Micro SD o SD Micro SD Micro SD
26
Reset