Zibro Laser FF 95 Manuel D'utilisation page 36

Chapter 1, INSTALLATION
5. Place the heater in the desired location. Attach the
right-angled exhaust bend to the outlet (the top open-
Fig. 11
6. Fasten the right-angled air hose to the inlet with the
hose clip. Attach the right-angled exhaust bend to the
exhaust pipe with the pipe holder (attach the pipe
holder to the connection of the right-angled exhaust
Fig. 12
7. Installation of an external fuel tank
The installation of an external fuel tank is illustrated in
a diagram (Fig. 1-11). The fact that installation tech-
niques for fuel tanks vary means that it is impossible to
37
Outlet
Inlet
Pipe lock
ing) and attach the right-angled air hose to the inlet.
Check that everything is firmly attached (See Fig. 11).
Right-angled exhaust bend
Right-angled air hose
bend). Attach the right-angled exhaust bend to the
outlet by sliding the pipe lock into the outlet clip (See
Fig. 12).
Pipe holder
provide a specific installation procedure. However, cer-
tain criteria determine the manner in which the heater
is supplied with fuel. Use the following checklist as a
guideline for the installation of an external tank.