Rearward Facing For Group 0; (Birth To 13Kg / Birth To Approx. 18 Months) - Hauck Varioguard Mode D'emploi

GB
REMOVING THE BASE - when attached to the ISOFIX points
Squeeze together the two isofix connection adjustment buttons
(R) located on either side of the support leg at the front of the car
seat base and pull the away from the vehicle seat (19).
Unlock the isofix points (Z) by pulling both latches (Q) toward the
front of the vehicle seat (20).
Then pull the car seat base forward on the vehicle seat to release
from the vehicle (21).

REARWARD FACING FOR GROUP 0+

(Birth to 13kg / birth to approx. 18 months)

Firstly you must install the car seat base into your vehicle using
either the seat belt or ISOFIX points. See sections 'Installing the
base - with a seat belt' or 'Installing the base - with ISOFIX'.
You must also ensure that the harness and headrest is set
correctly for your child, to do this see sections 'Headrest and
Safety Harness Adjustment' and 'Harness Tension and
Adjustment'.
The seat includes a seat liner and head hugger (C1) for the small
baby.
The liner has a cushion inserted in a pocket on the back of the
liner which is suitable for children up to approx 9Kg or 12 months.
For children over 9kg or 12 months remove the cushion and use
only the liner while the car seat is rearward facing.
INSTALLING THE CAR SEAT INTO THE BASE FULLY
RECLINED
Firstly make sure that the seat is in its fully reclined position. With
the car seat facing towards the rear of the vehicle, locate the bars
on the underside of the seat onto the attachment points on the
base and press the car seat down until you hear a "click" (19).
Check the seat is secure by lifting the seat upwards.
To remove the car seat from the base, press the car seat release
button (Y) at the front of the base while lifting the car seat up from
the base (10, 11).
INSTALLING YOUR CHILD IN THE CAR SEAT
Firstly open the buckle by pressing the red button in the centre of
31