Checklist; Installing The Base - With Isofix - Hauck Varioguard Mode D'emploi

WARNING! ENSURE THAT AT ALL TIMES THE SUPPORT
LEG IS IN CONTACT WITH THE FLOOR OF THE VEHICLE
AND THE INDICATOR IS GREEN.
To adjust the support leg, pull the RED support leg lock (T)
located on the of the support leg and extend the lower section of
the support leg until it reaches the vehicle floor (8). When the
support leg is locked into position you will hear a "click".
If the lock does not engage, extend the leg to the next lock
position.
IMPORTANT! Make sure the indicator (U) on the support foot is
green. If the indicator is red you must re-adjust the support leg.
To remove the car seat base from the vehicle simply open the belt
lock and remove the seat belt.

CHECKLIST

To ensure the optimum safety of your child, check the following
after installation:
- Check that the seat belt is as tight as possible and not twisted!
- Check that the diagonal and lap section of the vehicle belt
pass under the two red belt guides and through the red belt
lock (6) (7)!
- Check that the support leg is fully extended to the floor (3) and
locked into position and the indicator on the foot of the support
leg is green (8)!
- Check that the car seat base is installed securely and firmly in
the vehicle by trying to move it!

INSTALLING THE BASE - with ISOFIX

WARNING! ALWAYS GIVE PREFERENCE TO USING THE
REAR SEATS OF YOUR VEHICLE EVEN IF YOUR HIGHWAY
CODE PERMITS THE USE ON THE FRONT SEAT. CHECK
YOUR HIGHWAY CODE AS THIS REGULATION MAY VARY
ACCORDING TO THE COUNTRY. CHECK THE VEHICLE
MANUAL FOR ADVICE ON FITTING YOUR CAR SEAT IN THE
FRONT OF THE VEHICLE. AIRBAGS CAN CAUSE INJURY. DO
NOT USE THIS CHILD SEAT ON A PASSENGER SEAT FITTED
WITH A FRONTAL AIRBAG.
Fold the support leg out and place the car seat base onto the
vehicle seat (3).
GB
29