Victron energy BlueSolar PWM DUO-LCD-USB Mode D'emploi page 7

Battery2 display: battery2 voltage, battery state of charge,
charging status.
Press MENU to enter next display.
PV Voltage display: PV voltage and the state of charge of the
batteries.
Press MENU to enter next display.
Charge current display: Total PV to batteries1&2 current and the
state of charge of the battery.
If arrow is flashing charger is in float.
Press MENU to enter next display.
USB Voltage display: USB voltage
5V (2A max)
Press MENU to enter next display.
Internal controller temperature. If the
DUO 12V|24V|20A LCD-USB
down and wait for the temperature to drop to normal level and
then it will start working again.
Press MENU to enter next display.
External Temperature Sensor temperature. If the external
temperature sensor is connected, battery absorption voltages will
corrected with -30mV/°C for 12V and -60mV/°C for 24V
Without sensor the temperature is 25°C
Press MENU to enter Main display.
For use with External Temperature Sensor connect the sensor to
the BlueSolar PWM DUO 12V|24V|20A
5
BlueSolar PWM
gets hot during running it will shut