Intermatic Grasslin B15 Notice D'utilisation page 103

Menu
OK
Program
OK
New
With Date?
Yes/No
Fig. 34: Programming cycle switching
1. Press the
Menu
2. Select
Program
3. Select and confirm with
New
The number of available programme memory slots is displayed briefly (PXXX).
ð
The number of available switching programme memory slots is displayed briefly (dXXX).
4. In menu item
With Date?
date (Ä Chapter „Date-dependent/date-independent programming" on page 93).
5. Select the
Cycle
6. Enter the hours and minutes for the switching time (+/-) and confirm with
7. Enter period ON (+/-) and confirm with
8. Enter period OFF (+/-) and confirm with
9. Select day of the week (⋀/⋁) on which the cycle is to start and confirm with
The days of the week 1 – 5, 6 – 7 and 1 – 7 are set by default. Individual days of the week
can be set (+/-) under menu item "Select days".
10. Select channel (+/-) for which the cycle is to be set, and confirm with
The channel selection is only displayed if there are two or more channels.
+ Active channel
– Inactive channel
11. To create a new switching time, select
OK
Select FNC
Cycle
Time
09:00
...minutes
OK
Period ON
00:10:00
...minutes
Period OFF
00:30:00
...minutes
button.
and confirm with .
OK
.
OK
, specify whether the switching programme is to be programmed with a
function and confirm with
OK
OK
YES
Days
12345--
Mon – Fri
OK
Channels
––
CH1
OK
OK
.
OK
.
.
and confirm with .
OK
OK
OK
OK
Add
switching time?
Yes/No
OK
Priority
High
.
OK
.
OK
.
OK
EN
103