Citizen CT-S801 II Mode D'emploi page 60

The situation during various errors is shown below.
The LCD's top line is the type of error, the bottom line is the remedy. Scroll
through messages that are longer than 16 characters.
Status
Paper near-end
Paper-end
Front cover open
Paper cover open
Cutter locked
Print head hot
Memory error
System error
Low-voltage error
High-voltage error
Black mark label error
Sensor calibration error
Waiting for macro to
execute
*1
Notes:
*1: LED may light while macro is executing.
*2: Buzzer sounds when MSW5-1 (buzzer setting) is set to ON. Note, however, that some combinations of
settings of MSW5-1 and MSW10-6 may change the condition in which buzzer sounds.
Message
PAPER LOW
Paper end
Please replace paper roll.
Front cover open
Please close front cover.
Paper cover open
Please close paper cover.
Cutter lock
Open paper cover & remove jam.
Head overheat
Please wait, will continue
—
System error
Please contact your dealer
L Voltage Error
Please contact your dealer
H Voltage Error
Please contact your dealer
BM/Label Error
Please check paper/calibration.
Calibration Err.
Please check paper.
Press a key
-> Executing macro
— 56 —
LED Backlight
Orange —
Red Red
Red —
Red —
Red Red
Orange —
Red —
Red Red
Red Red
Red Red
Red Red
Red Red
Flashing —
green
Buzzer
*2
No
Yes
Yes
Yes
Yes
No
No
No
No
No
Yes
Yes
No