Maintenance And Care; Replacing The Rotor Blades; Replacing The Tail Rotor Propeller - Reely SKY Exceed Notice D'emploi


14.

Maintenance and Care

Clean the exterior of the model and the remote control only with a soft, dry cloth or brush. Never use abrasive cleaning
agents or chemical solutions as these could damage the surfaces of the casings.
All moving parts have to be easily movable but there should not be a clearance in the bearing. The motor shafts with
the rotor shaft must be aligned perfectly straight and must not be eccentric.
a) Replacing the Rotor Blades
If contact with an obstacle leaves visible danger on a rotor blade
(cracks or broken parts), the rotor blade must be replaced.
First, the linkage rods (1) must be carefully removed from the rotor
blade ball joints. Then the retaining bolts (2) are removed.
Then the two rotor blades are separated and removed from the
rotor head.
When assembling the new rotor blades, first push the two rotating
pins (3) into the rotor head and then assembly the two blades.
Turn in the retaining bolts again when the rotor blades are correctly
assembled.
Finally, attach the linkage rods again.
b) Replacing the Tail Rotor Propeller
The propeller of the tail rotor (1) is pushed onto the motor shaft (2)
and can be easily removed from the shaft.
Pull off the defective propeller with the fingers and ensure that the
motor shaft is not bent when pulling it off and pushing it on.
62
Figure 26
Figure 27