Setting Up The Transmitter; Inserting The Batteries - Reely SKY Exceed Notice D'emploi



9. Setting Up the Transmitter

In the further course of these instructions, figures in the text always refer to the adjacent figure or the figures
within the section. References to other figures are indicated with the corresponding figure number.
a) Inserting the Batteries
The power supply of the transmitter requires 6 mignon batteries (e.g. Conrad item No. 652506, please order 6x).
Important:
Use batteries only (1.5 V/cell) instead of rechargeable batteries (1.2 V/cell) for transmitter power supply.
Proceed as follows to insert the batteries:
The battery compartment lid (1) is located on the back of the
transmitter. Use a suitable screwdriver to turn out the attachment
screw (2) and lift off the lid.
Then put 6 batteries into the battery compartment. Observe the
correct polarity of the cells. The polarity is indicated at the bottom
of the battery compartment.
Insert the battery compartment lid with the two latching tabs into
the transmitter housing at the bottom edge and screw it back on.
Figure 2
41