Reely SKY Exceed Notice D'emploi page 59

Proceed as follows to switch the control stick assignment:
• Switch on the transmitter.
• Push and hold the left switching button for servo path limitation
to enter the programming menu.
• Operate the left trimming button for the tail function immediately
to call the first menu item „THRO".
• Select the menu item „STICK MOD" with the trimming buttons
for the roll function.
• Operate the left trimming button for the tail function again to
switch from the menu item to the input value. The currently set
value (e.g. „2") starts to flash.
• Now you can use the trimming buttons for the rolling function to
switch on the desired control stick assignment.
• Push the left trim button for the tail function again to save the
set value.
• To leave the programming menu, push the right trim button for
the tail function 2 x or wait until the programming menu is closed
automatically.
If the transmitter is to be operated in modes 1 or 3, not only the control levers, but also the functions of the
switch for control sensitivity (see figure 1, item 9) are swapped with the functions of the trim buttons for the
nod function (see figure 1, item 2).
Figure 23
59