Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 48
4.
Select the fan level. To do this,
press the
key.
The dehumidifier runs until the target
room humidity has been reached or the
basin is full, then it will stop running.
Emptying the basin
The "Basin full" indicator flashes, the
basin is full.
Procedure
1.
Release the basin lock.
2.
Empty the basin.
3.
Secure the basin again with the ba-
sin lock.
Night mode
If necessary, night mode can be enabled
for quieter operation for 10 hours.
1.
Press the
key.
The dehumidifier runs for 10 hours at
level 1.
Switching off
Procedure
1.
Empty basin if necessary.
2.
Set on/off button to "0".

11 Maintenance and care

WARNING! Electrocution!
Always disconnect the mains plug to
disconnect the dehumidifier from
the power supply before cleaning
the defrosting tray of the AD40.
WARNING! Damage to health from
dust!
Only clean the dehumidifier with
compressed air in open spaces.
Wear a protective mask and gog-
gles.
ATTENTION! Damage to property!
Cleaning agents can damage sur-
faces. Only use mild detergents.
Only use approved original spare
parts.
Cleaning and inspection
Procedure
1.
Switch off the dehumidifier.
2.
Unplug the mains plug.
3.
Remove and clean the air filter
(e.g. with vacuum cleaner) or
replace it.
4.
Check the discharge nozzle and dis-
charge hose, if connected.
5.
AD 740 only: Pull out the drip tray
slightly and wipe with a cloth.
AD 40 only: Remove the filter
6.
holder. To do this, undo the four
marked screws with a suitable
screwdriver and remove the filter
holder.
21

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ad 40 série

Table des Matières