Candy CCT 685/2 X Manuel De L'utilisateur page 8

2. Position the hood against the wall that you are intending to install it on
and mark the position of the support holes that are to be drilled (as
shown in the figure below).
2a. The support screw holes are indicated by figure A in this drawing and
the anchoring screw holes are indicated by figure B.
3.Using a drill bit with a 6 mm diameter, make holes
in the wall on the positions that you have marked in
step 2.
4. Insert rawl plugs into all of the holes that you have drilled.
5. Fasten the support screws halfway in, leaving them 10 mm out of the
wall.
6. Hang the hood onto the support screws.
7