Agu Tomchi N8 Mode D'emploi page 132

ELECTROMAGNETIC COMPATIBILITY: INSTRUCTIONS AND STATEMENTS OF
THE MANUFACTURER - FOR A DEVICE THAT IS NOT A LIFE SUPPORT DEVICE
Electromagnetic compatibility: instructions and statements of the manufacturer
The device is intended for use in the electromagnetic environment described below.
Buyers and users of the device must ensure that it is used in an environment that
meets the guidelines
Immunity test IEC 60601 Test
HF
conductivity
IEC 61000-4-6
HF emanation
IEC 61000-4-3
NOTE 1
At 80 MHz and 800 MHz, the values for the high-frequency range are used.
NOTE 2
These instructions may be applicable not in all situations. The propagation
of electromagnetic waves is affected by their absorption and reflection by
structures, objects, and people.
132
.
Compliance
level level
3 V (avg.)
3 V (avg.)
150 kHz – 80
MHz
3 V/m 80MHz –
3 V/m
2,5 GHz
Electromagnetic environment-
guidance
Portable and mobile radio communi-
cation equipment should not be used
closer to any part of the device (includ-
ing cables) than the recommended
minimum distance calculated with the
appropriate equation for the frequency
of the transmitter of such equipment
d = 1,2√P
d = 1,2√P 80 MHz – 800 MHz
d = 2,3√P 800MHz – 2,5GHz
Where P is the maximum transmit-
ter power in watts (W) specified by the
manufacturer and d is the recommend-
ed minimum distance in meters (m)
The measured values of the elec-
tromagnetic force produced by the
stationary radio transmitter
less than the corresponding allowable
values for all frequency
b.
bands There may be
interference near equipment
with the following symbol
a
should be