Agu Tomchi N8 Mode D'emploi page 116

Make sure that the medication chamber is installed correctly; otherwise,
problems in the device operation may arise.
Please keep the electrodes of the main unit and the medication chamber
clean; otherwise, problems in the device operation may arise.
Clean the medication chamber after each use.
HOW TO USE A NEBULIZER
Before assembling the device, you can pour 0.9% sodium chloride solution (table
salt) into the medication chamber before use, and then press the «I/O» button. If the
nebulizer does not spray the liquid, refer to part «Troubleshooting» on page (123).
1. Turn on the power.
a) Press the «I/O» button, the power indi-
cator should constantly light (green). The
backlight of the medication chamber
should constantly light (blue) (1.1).
b) Medication indicator with a blue light
blue light flash with 1Hz if no medication
(empty & depleted) (1.2).
WARNING
If you turn on the device with an empty medication chamber, the power
indicator will turn green for a short time before it goes out. After that, the
illumination of the medication chamber will start blinking blue for about
15 seconds, then the device will automatically turn off.
During operation, if the medication is finished in the medication chamber,
the power indicator will turn off, and the illumination of the medication
chamber will start blinking blue at a frequency of 1 time per sec. for about
15 seconds, then the illumination will turn off and the device will automati-
cally turn off.
Maximum continuous operating time of the nebulizer: 30 minutes.
116
1.2
1.1