Quick Installation - Tripp-Lite SmartPro VS 2200 Manuel Du Propriétaire

Quick Installation

Plug the UPS into an outlet
1
on a dedicated circuit.*
NOTE! after you plug the UPS into a live AC
outlet, the UPS will automatically charge its
batteries,** but will not supply power to its outlets
until it is turned ON (see Step 3 below).
* See Specifications for circuit amperage requirements. **
The BATTERY CHARGE LED will be the only LED
illuminated.
Plug your equipment into
2
the UPS.*
* Your UPS is designed to only support computer
equipment. You will overload the UPS if the total VA
ratings for all the equipment you connect exceeds the
UPS's Output Capacity (see Specifications). To find your
equipment's VA ratings, look on their nameplates. If the
equipment is listed in amps, multiply the number of amps
by 120 to determine VA. (Example: 1 amp × 120 = 120
VA). If you are unsure if you have overloaded the UPS's
outlets, see "OUTPUT LOAD LEVEL" LED description.
Turn the UPS ON.
3
Press and hold the "POWER" button for one
second. The alarm will beep once briefly after one
second has passed. Release the button.
Note: UPS system will function properly upon initial
startup; however, maximum runtime for the unit's battery
will only be accessible after it has been charged for 24
hours.
201112099 931874.indb 3
1
SMART2200VSXL shown
2
SMART2200VSXL shown
3
3
12/28/2011 4:44:06 PM