Armlift Height; Adjusting The Turntable Startup/Brake Speed - Technics SL-1200GR Mode D'emploi

Armlift height

Make an adjustment according to your
cartridge if necessary.
Preparation
 Put a record on the turntable.
 Remove the stylus cover, taking care not
to damage the stylus, then release the arm
clamp.
 Lift the cue lever and move the tone arm over
the record.
1
Check the armlift height (distance
between the stylus tip and record
surface).
If adjustment is needed, go to
step 2 .
 The armlift height is factory-adjusted to
8 to 13 mm.
2
Return the tone arm to the arm
rest and fix it with the arm clamp.
Turn the adjustment screw.
 Turning the screw clockwise lowers the
armlift.
 Turning the screw anti-clockwise raises
the armlift.
Armlift
Adjusting the turntable startup/
Confirmation lamp
 Press the centre of the button lightly.
You can select from three options of the startup
speed (the time to reach the constant speed) after
[START-STOP] is pressed and the torque gain at the
constant speed.
(Factory setting: 3)
[3]
[1]

The confirmation lamp blinks the specified number
of times according to the current setting when you
press the H or L torque button.

To change the setting, press the H or L torque
button while the lamp is blinking.
Example: If the current setting is [3] and you

After you press the torque button, the
confirmation lamp blinks the specified number of
times showing the new setting, stays lit for two
seconds and then goes off.
You can select from five options of the brake speed
to stop the turntable after [START-STOP] is pressed.
(Factory setting: 5)
[5]
[1]
Armlift
screw

The confirmation lamp blinks the specified number
of times according to the current setting when you
press the F or S brake button.

To change the setting, press the F or S brake
button while the lamp is blinking.
Example: If the current setting is [5] and you

After you press the brake button, the confirmation
lamp blinks the specified number of times showing
the new setting, stays lit for two seconds and then
goes off.
brake speed
BRAKE button
S (Slow)
F (Fast)
Torque button
L (Low)
H (High)
Startup speed
Fast startup
Slow startup
press the L button twice, the setting will
change to [1].
Brake speed
Stops fast
Stops slowly
press the S button twice, the setting will
change to [3].
21
(21)
English