Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
SWITCH OPERATION
The TLR-7
and TLR-8
®
constant activation and allows selection of the light/laser (TLR-8
• A tap on either switch turns the unit "on" or "off".
• Press and hold either switch for momentary activation of the unit.
• To cycle through the available modes (TLR-8
one switch and tap the other switch until desired mode is reached. The selected mode will
be saved when unit is turned "off".
• NOTE: The TLR will not operate if the facecap is in "safe" mode.
Laser Adjustments
Strobe Enable/Disable
The TLR-7
and TLR-8
®
starting from the "Off" position, tap either switch very rapidly 9 times (within ¼ second per
tap) and hold down on the 10th time. Hold the switch until the light turns off (about one
second) which indicates reprogramming was successful. Repeat the procedure above
to disable strobe mode.
Strobe Operation
The TLR-7
and TLR-8
®
Within ¼ second, press either switch, release and immediately re-press for strobe.
TLR-8
LASER SIGHT ZEROING
®
For a laser mounted below or to the side of the bore, there is only one distance where the
bullet path will coincide with the laser sight line. This point is the "zero range". Laser adjust-
ment and the muzzle velocity of the bullet determine where this point occurs. The user must
decide how high above or below the sight line the bullet can be allowed to strike and adjust
the sight accordingly. At distances less than the zero range the bullet will be above the sight
line. Beyond the zero range the bullet will be below the sight line. If mounted to the side,
the bullet will also deviate to the side of the laser line, as well as up and down. In practice, a
TLR-8
on a handgun can be adjusted to keep the bullet strike within about 2" high and 2"
®
low out to about 100 feet.
There are two adjustment screws located on the left side of the flashlight body. The windage
adjustment is located closest to the bottom of the flashlight. Turn the set screw clockwise to
move the laser to the left (POI right). Turn the set screw counter-clockwise to move the laser to
the right (POI left). The elevation adjustment is located higher up on the flashlight body. With
the TLR-8
pointed down range a clockwise turn of the adjustment screw will move the laser
®
up (POI down). A counter-clockwise turn on the adjustment screw will move the laser down
(POI up). Move the laser dot in the direction that the shots are hitting the target (example:
If the bullets are striking low and right, move the laser dot down and right to coincide with
the bullet strike).
feature ambidextrous side switches that provide momentary or
®
ship from the factory with the strobe mode disabled. To enable strobe,
®
strobe mode can be activated by either switch.
®
only; Light, Laser, Light/Laser), press and hold
®
Switches
only).
®
Publicité
Table des Matières
