Switching Off - Würth MLL12 Traduction Des Instructions De Service D'origine

Horizontal / vertical operation
The horizontal lines and the vertical lines can be used
in any combination. ÀJ ,,
Operation with hand-held receiver
Press button for operation with hand-held receiver
[6].
3 The indicator [7] illuminates in green. You can now
detect the beam in a distance of up to 60m with
your hand receiver.
Note
The function is only available if either hori-
zontal or vertical lines are switched on.

Switching off

knob [1].
3
$FFXUDF\ WHVW ÀJ 9,
Perform the accuracy test before using the device
of deviations, send the device to Würth Master
Service.
Horizontal accuracy (fig. III)
Set up the device between two walls, maintain
from the other wall.
Switch on the 360° horizontal line and all
vertical lines.
Mark point a
1
distance (intersection of horizontal and vertical
line).
Mark point b
on the wall in 10m distance.
1
Turn the device by 90°.
Align the horizontal beam such that it is identical
in height with point a
beam and point b
Note
Turn the device twice in steps of 90°.
.
1
.
1
Vertical accuracy (fig. IV)
Set up the device at a distance of 5m from a
wall.
Hang a plumb bob with a rope of at least 2m
length on the wall.
Switch on the middle vertical lines.
Align the vertical line with the plumb line by
curacy.
90° accuracy of the vertical line (fig. V)
Place the device in the corner of a room with
side lengths of 3.2m and 4.2m.
Switch on all vertical lines.
device alongside the vertical laser line and mark
point A
device alongside the second vertical laser line
and mark point B
Measure distance C between A and B, it should
Repeat this procedure with the 3rd vertical line.
Accuracy of the downward plumb beam
and the laser cross on the ceiling (fig.VI)
Set the device on a tripod (accessory). Ensure
that the device is 1.2m above the ground.
Switch on the downward plumb line and mark
point a
.
1
Turn the device by 180° and mark point a
a and a
1 2
D4. The distance should
-
.
2
15