COMAC CA30 Manuel D'utilisation page 12

ATTENTION! The vacuum cleaner is furnished with a system which interrupts the
suction when the tank has reached its maximum capacity. When this occurs,empty the
tank, following the instructions in this booklet.
ATTENTION! for particular thick liquids suction (chemical water with shavings,
mud, leaves) use the special nylon filter (optional).
CLEANING AND MAINTENANCE OF THE VACUUM CLEANER:
Disconnect the plug from the source of electricity (figure 26), unhook the tank latches
(figure 27) and remove the head and the dust filter from the tank (figure 28). Bend the
vacuum cleaner until the handle touches the floor and empty the contents of the tank
into another container (figure 29). Then put the tank back into its original position
(figure 30) and if necessary (for dry vacuum cleaning only) insert the dust filter (figure
3), place the head in its correct position and secure it onto the tank with the latches
(figure 31) and start cleaning again.
ATTENTION! Before performing any cleaning and maintenance on the vacuum
cleaner, always disconnect the plug from the source of electricity.
Make sure that the cable is not cut or damaged (if it is, apply to the nearest authorized
service centre for replacement).
a) Clean the tank, do not let it stand for a long time with dust or dirty water.
b) Clean the cloth filter frequently.
c) Always use only original replacement parts and attachments.
TROUBLE-SHOOTING:
1) SYMPTOM: The machine does not work. CHECK the following points:
a) Check if the plug is connected to the source of electricity.
b) Check if the switch is in the on position.
c) The tank may be filled with liquid. lf it is, empty the tank, following the
instructions given in this booklet.
2) SYMPTOM: The machine does not have enough aspiration. CHECK the following
points:
a) The filters may be dirty. lf they are, clean or replace them, following the
instructions given in this booklet.
b) The suction hose may be obstructed. lf it is, turn off the vacuum cleaner by
pushing the switch to the off position, and then remove the cause of obstruction.
c) The tank entry may be obstructed. lf it is, turn off the vacuum cleaner by pushing
the switch to the off position, and then remove the cause of obstruction.
lf the malfunction is not caused by any of these points, apply to the nearest service
centre for an examination of the vacuum cleaner. The motor is built for maintenance-
free operation and does not need any particular service. The carbon brushes may need
to be replaced due to normal wear and tear caused by using the vaccum cleaner over
time, and they can be replaced only by our authorized service centres.
The manufacturer reserves the right to modify the machine and the included
attachments without prior notice