Toshiba RAS-M10SMUV-E Manuel D'installation page 13

Installation of hanging bolt
Use M10 hanging bolts (4 pieces, locally procured).
When mounting the unit, set the pitch of the hanging bolts according to the size of the unit as detailed on the dimensional drawing.
New concrete slab
Install the bolts with insert brackets or anchor bolts.
(Blade type bracket)
Steel flame structure
Use existing angles or install new support angles.
Hanging bolt
Existing concrete slab
Use a hole-in anchors, hole-in plugs, or a hole-in bolts.
Installation of indoor unit
• Attach the nut (M10 or W3/8: Procured locally) and washer (34 mm
(diam.)) to the hanging bolt.
• Put washers at either side of the T-groove on the hanging bracket of the
indoor unit in order to hang the unit.
• Using a spirit level, check that all four sides are horizontal. (Horizontal
positioned within 5 mm)
• Cut off the installation gauge from the installation pattern.
• Using the installation gauge, check and adjust clearance between the
indoor unit and the ceiling opening (1) (10 to 42 mm on each side).
Ensure that the unit is level to the ceiling and within a distance of (2) 23 mm
to 28 mm below.
The installation gauge has details of how to use printed on it.
NOTE
Install the indoor unit so that the end part of opening does not come into contact with the drain socket piping.
Level vial (Horizontal: within 5 mm)
Indoor unit
Hanging
metal
10 to 42 mm (1)
Installation gauge
(Slide type bracket)
Hanging bolt
Support angle
Hanging bolt
23 to 28 mm (2)
Indoor unit
Ceiling board
Ceiling board
Reinforcing steel
Anchor bolt
(Pipe hanging anchor bolt)
Hanging bolt
(W3/8 or M10)
Nut
(W3/8 or M10)
(1) M10 washer supplied, all other material must
(2) To ensure that the unit is mounted safely, the
23 to 28 mm (2)
10 to 42 mm (1)
Installation
gauge
9
(1)
M10 flat washer
(Accessory)
(2)
M10 flat washer
(Accessory)
Nut
(W3/8 or M10)
be procured locally.
hanging bolt must be positioned just below
the hanging bracket as shown in the diagram.
EN