The "Alarm Settings" Page - Kompernass IUK 5 A1 Mode D'emploi

The "Alarm settings" page

Alarm settings
GB
If you check the box "Alarm triggered by motion detection", the content of the window will change.
Now you can adjust the motion detection sensitivity for the alarm ("High", "Medium" or "Low").
If you check the box "Alarm triggered by audio detector", the alarm can be triggered by an audio
signal recorded on the camera. Under the menu item "Alarm-audio detection sensitivity" you can set
which sensitivity level the device should use for this purpose: "High", "Medium" or "Low".
If you check the box "Alarm triggered by external detector", the device will react accordingly to an
alarm signal from an external alarm trigger connected to the alarm connection. Then you can set the
threshold in the line "Trigger level" to "High" or "Low".
If you want to see a specific "Preset position when alarm is triggered", choose the desired position
that was previously stored from the selection box under this menu item.
IUK 5 A1 107