DENTSPLY Luci-Sof Mode D'emploi page 3

Step-by-Step Instructions for Relining a Denture
Fig. #A
Fig. #B
Fig. #C
Fig. #D
Luci-Sof Injectable Soft Denture Liner is a long-term silicone,
heat-cured soft denture liner material. This product requires
the use of the Success Injection System.
1. Pour a stone cast of the impression in the denture to
achieve the desired contour (see Fig. #A).
2. Trim excess impression material smooth with wax, and
finish to final shape around the periphery. This prepa-
ration will help to minimize finishing. Optional method
is to use a reline jig method before investing. This pro-
vides easy access for denture preparation and will
help to minimize finishing (see Fig. #B).
3. Invest in bottom half of the flask.
4. Sprue according to Success System directions
®
(Success Sprue Wax, Item #904584, is recommend-
ed). For lower dentures, place sprues as far back on
the lingual surface as possible (see Fig. #C).
Optional: Use Dentsulate
deflasking.
5. Invest top half of the flask.
6. Open the flask and remove wax with boiling water.
7. Remove the impression material.
8. Wash with detergent and water, and rinse with clean
boiling water.
9. Grind the denture surface with a clean Faskut
Carbide Cutter or coarse diamond stone to remove
tray adhesive and sufficient acrylic. Grind flange bor-
der to a 90° butt joint.
Denture
Base
Avoid knife edges. A rough and clean surface is nec-
essary to achieve a superior bond to the denture base.
(see Fig. #D)
2
®
insulating putty to aid in
Luci-Sof
®