Information For Test Institutes; Settings - AEG FSE62400P Notice D'utilisation

8 www.aeg.com
Programme
P2
P3
P5
P6
P4
1) The pressure and the temperature of the water, the variations of the mains supply, the options and the
quantity of dishes can change the values.
5.2 Information for test
institutes
For all the necessary information for test
performance, send an email to:

6. SETTINGS

6.1 Programme selection
mode and user mode
When the appliance is in programme
selection mode it is possible to set a
programme and to enter the user mode.
In user mode, the following settings
can be changed:
• The level of the water softener
according to the water hardness.
• The activation or the deactivation of
the acoustic signal for end of
programme.
• The activation or deactivation of the
rinse aid empty notification.
• The activation or the deactivation of
AirDry.
These settings will be saved until you
change them again.
Water
1)
(l)
6 - 12
11 - 13
8
9 - 11
10 - 12
Energy
(kWh)
0.5 - 1.2
1.0 - 1.2
0.6 - 0.8
0.9 - 1.1
0.8 - 0.9
info.test@dishwasher-production.com
Write down the product number (PNC)
that is on the rating plate.
How to set the programme
selection mode
The appliance is in programme selection
mode when the display shows the
programme number P1.
When you activate the appliance, usually
it is in programme selection mode.
However, if this does not happen, you
can set the programme selection mode
in the following way:
Press and hold RESET until the appliance
is in programme selection mode.
6.2 The water softener
The water softener removes minerals
from the water supply, which would have
a detrimental effect on the washing
results and on the appliance.
The higher the content of these minerals,
the harder your water is. Water hardness
is measured in equivalent scales.
Duration
(min)
40 - 150
130 - 150
30
220 - 230
60 - 80