Dometic CFF12 Notice D'utilisation page 19

CFF12, CFF35, CFF45
A
NOTICE! Damage hazard
Disconnect the cooler and other consumer units from the battery before
you connect the battery to a quick charging device.
Overvoltage can damage the electronics of the device.
For safety reasons the cooler is equipped with an electronic system to prevent
polarity reversal. This protects the cooler against short-circuiting when connecting to
a battery.
Using the fused DC plug
A
NOTICE! Damage hazard
For protection of the device the DC cable supplied includes a fuse inside
the plug. Do not remove the fused DC plug.
Only use the DC cable supplied.
1. Plug the DC connection cable (fig. 1 2, page 3) into the DC voltage socket of
the cooler (fig. 4 4, page 4).
2. Connect the connection cable to a DC power outlet.
Connecting to an AC power supply
D
DANGER! Electrocution hazard
Failure to obey these warnings will result in death or serious injury.
• Never handle plugs and switches with wet hands or if you are stand-
ing on a wet surface.
• If you are operating your cooler on board a boat from a AC power
supply, you must install a residual current circuit breaker between the
AC power supply and the cooler.
Seek advice from a trained technician.
The coolers have an integrated multi-voltage power supply with priority circuit for
connecting to an AC voltage source. The priority circuit automatically switches the
cooler to AC operation if the device is connected to an AC power supply, even if the
DC connection cable is still attached.
When switching between the AC power supply and the battery supply, the red LED
may light up briefly.
1. Plug the AC connection cable (fig. 1 3, page 3) into the AC voltage socket of
the cooler (fig. 4 1,page 4).
2. Connect the connection cable to an AC power outlet.
EN
Operation
19