Thermador T24UC925DS Guide D'installation page 17

Bottom drawer:
1. Install the custom handle of your preference on the overlay panel before installing the panel on
the drawer.
- Every custom handle is different, and it is the responsibility of the customer to make the
necessary adjustments to place the handle on the overlay panel.
- The screws used to affix the custom handle to the panel must be flat and flush with the surface
of the panel (Fig A); if the screws are not flat, then consider making a recession on the overlay,
enough to hide the head of the screw below the surface of the overlay, otherwise the screws will
interfere with the correct placement of the overlay on the drawer (Fig B).
Overlay Frame with custom
Flat screw flush with surface
(Fig A)
Door
Round head screw hidden in a recession on the overlay.
Overlay Frame with
custom handle
Page | 17