Setting Indoor Unit; Mode; Date And Time - Alecto WS-3850 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

6.

SETTING INDOOR UNIT:

6.1

Mode:

Use the mode button to select the desired adjustment function:
Press Mode
for the following settings

date and time

alarm time for the alarm clock
height correction setting
temperature alarm setting for outdoor and indoor temperature
rain gauge display extension in mm or inches
wind speed display extension in km/h or mph
6.2
Date and time:
The time and date are automatically received via DCF-77 receiver which
receives the time data. This receiver is situated in the wind unit. The wind
unit must be switched on for at least 5 minutes to receive the DCF-77
signal. If the channels of the wind unit and the indoor unit are the same,
the outdoor temperature will be the first to appear in the display during
registration. Followed later by the correct time. The wind unit must be
switched on for approximately 2 minutes for the signal to be transmitted.
Alternatively, you can use the TX button in the battery compartment to
transmit manually. The wind unit should already be switched on for several
minutes at this point. Once the DCF signal is received, the following icon will
appear next to the time:
. If DST appears below this icon ( ) then daylight
saving time is active (DST - Day Saving Time).
not appear. The time and date must then be re-set manually.
zone
press the Mode key 1 x
Press the Set key for 3 seconds
AA 1,5V
Select zone starts to flash. Enter the desired value for the DCF time
AA 1,5V
zone using the up
and down
Netherlands this is 0) The DCF time takes daylight saving time into
AA 1,5V
account.
AA 1 V
AA 1,5V
A
Pressing the WAVE button for a few
seconds will disable reception of the
DCF signal. Then wait a day and the
DCF-77 receive symbol
will disappear.
It is also possible to restart the indoor
unit. The receive symbol will then also
. Date and time setting is displayed
keys. (In the DCF time zone of the
day name language
Press the Set key again
German, French, Italian, Dutch, Spanish or Danish. Select the desired
language with up
and down
year
Press the Set key
again to continue setting the year. Select the
desired year with the up
month-day / day month sequence
Press the Set key
again to continue setting the day or month
sequence. Select the desired month-day or day-month indication with
up
and down
keys.
month
Press the Set key
again to continue setting the desired month
(1-2-3..to..12). Select the desired year with the up
keys the desired month indication.
day
Press the Set key
again to continue setting the desired day
(1-2-3..to..31). Select the desired day with the up
keys.
12/24 hour display
Press the Set key
again to continue setting the desired hour format
(12 or 24 hours). Select the desired hour format with the up
down
keys.
hour
Press the Set key
again to continue setting the desired hour Select
the desired hour with the up
minutes
Press the Set key
again to continue setting the desired minutes.
Select the desired minutes with the up
seconds
Press the Set key
again to continue setting the desired seconds.
Select the desired seconds with the up
9
to continue setting the day in English,
keys.
and down
keys.
and down
and down
and down
keys.
and down
keys.
and down
keys.
and

Publicité

Table des Matières
loading

Table des Matières