D- Using Your Product - Ugur UDD 45 DTK Guide D'emploi

C- INSTALLATION OF YOUR PRODUCT
Electric Connection Rules
The product will start when you insert the plug into the outlet as shown in picture 8.
WARNING!
It is forbidden to insert the plug into multiple socket and to use extension cord. (Picture 9)
There is no separate on-off switch on your product.
Do not contact the cables of your product, which are connected to the mains, to hot surfaces.
The outlet you will use must be grounded. Furthermore, the outlet to be used must have the resistance of
at least 10-16 A and be protected with a suitable fuse. Definitely take assistance from our technical service
or a competent electrician with regards to the fuse that should be present on the mains where the outlet is
connected.
Mains voltage and frequency must be same with the value written on the label inside your product. If your
mains voltage is extremely below or above the value indicated, definitely supply demanded voltage by us-
ing a voltage regulator. You can get assistance from an expert electrician with this regard.
Do not place your product's cord onto passageways. This may cause you to get injured and damage your
cooler. (Picture 10)
EN
PICTURE 8 PICTURE 9 PICTURE 10
44

D- USING YOUR PRODUCT

Start-up
WARNING!
• This operating manual applies for various device models. Hardware scopes of the models may vary. There
may be differences in the pictures.
• Clean inside and all accessories of your product before the first start up. (see page 22).
• If your product has been shaken so much during the transportation and positioning, wait for one (1) hour
without running it. Thus, the compressor oil, which may enter into the system, will return back. You may
damage the compressor if you run it without considering this.
• Insert your product's plug into an outlet with alternative current of 220-240V/50 Hz only, which has been
installed according to the regulations. (Picture 11)
• You will hear a slight sound from the compressor when your product is running.
• The fan inside your product will stop once you open the door of your cabinet.
• If the lights of your product do not light, put the 0-1 switch under the canopy to position 1. (Picture 12-13)
PICTURE 11 PICTURE 12 PICTURE 13
45
EN