Using Your Product - Ugur HSC300N Mode D'emploi

UPRIGHT FREEZER SHOWCASE
Original Instructions
t
HSC300N
1. The outlet you will use must be grounded. Furthermore, the outlet to be used must have the resistance of at least 10-16 A and be protected with a suitable
fuse. Definitely take assistance from our technical service or a competent electrician with regards to the fuse that should be present on the mains where
the outlet is connected.
2. Mains voltage and frequency must be same with the value written on the rating label at the back of your product. If your mains voltage is extremely below
or above the value indicated, definitely supply demanded voltage by using a voltage regulator. You can get assistance from an expert electrician with this
regard.
3. Do not place your product's cord onto passageways. This may cause you to get injured and damage your cooler. (Picture 13)
PICTURE 12

4. USING YOUR PRODUCT

Start-up
WARNING!
• Clean inside of your product before the first start up.
• If your product has been shaken so much during the transportation and positioning, wait for one (1) hour without running it. Thus, the compressor oil, which
may enter into the system, will return back. You may damage the compressor if you run it without considering this.
• Insert your product's plug into an outlet with alternate current of 230 V / 50 Hz only, which has been installed according to the regulations. (Picture 14)
• You will hear a slight sound from the compressor when your product is running.
• The fan inside your product will stop once you open the door of your cabinet.
• If the lights of your product do not light, put the lighting ON/OFF switch to position I. (Picture 15)
PICTURE 14
Setting Internal Temperature of Your Device
1. Temperature setting of your product has made at the factory in a manner that it is operated under the most appropriate conditions.
2. Be careful for always placing frozen product inside your product.
3. Preservation temperature of the products can be observed from the digital indicator.
4. Set value of your product has been adjusted at the production plant as 4. This value is the value that can protect the products inside of your device without
spoiling under any conditions.
5. When you run your product at factory set value, you get the best result in terms of both the performance and energy consumption.
6. Run your device empty for at least three (3) hours. Therefore inside of your product will be cooled down in the best way.
• Internal temperature of your product can be adjusted between - 12 °C to - 22 °C.
• Temperature setting: 0 - 7 (on control panel (A))
0 - off
1 - highest temperature setting (about -12°C)
7 - lowest temperature setting (coldest, about -22°C)
Manufacturing setting: 4
Loading foodstuff to your product
You can load your foodstuff as permitted in this manual after your product reaches to desired temperature at empty state.
CAUTION!
• Do not place products, which are dangerous to be cooled down, inside you product.
• Leave a gap of at least two (2) cm between the top and the product you load for ensuring air circulation.
• Do not overload the shelves.
MODEL MAX. SHELF CARRYING CAPACITY
HSC300N
(IM)961-000669_HSC300N_GB&DE_IM_V5_161121.indd 9
PICTURE 13
PICTURE 15
16 kg
- 9 -
2
1
3
0 4
7
5
6
11/21/16 2:21 PM