Ugur UDD 45 DTK Guide D'emploi page 24

D- USING YOUR PRODUCT
Setting Internal Temperature of Your Device
Temperature setting of your product has made at the factory in a manner that it is operated under the
most appropriate conditions.
Be careful for always placing frozen product inside your product
Preservation temperature of the products can be observed from the digital indicator or thermostat
under its canopy and adjusted by means of an electronic thermostat.
Set value of your product has been adjusted at the production plant as -22°C. This value is the value
that can protect the products inside of your device without spoiling under any conditions.
When you run your product at factory set value, you get the best result in terms of both the perfor-
mance and energy consumption.
Run your device empty for at least three (3) hours. Therefore inside of your product will be cooled
down in the best way.
WARNING!
• Internal temperature of your product can be adjusted between -18°C and -25°C. (In models
with a digital thermometer, adjustment can only be made by an Authorized Uğur Service.)
• Always provide a gap between the top and the product you load for ensuring air circulation.
EN
46
D- USING YOUR PRODUCT D- USING YOUR PRODUCT
Using digital thermostat
If the product you've purchased is equipped with a digital thermostat, please pay attention to the following matters.
Digital thermostats are factory set and do NOTE require any setting. You can change the thermostat setting as shown
below.
Digital thermostats contain many programs (such as eco mode, night mode). If you believe that there is a problem in
your product related to the operation or cooling, please consult to authorized service.
Error codes given by the digital thermostats are under the troubleshooting title. When you encounter these error codes,
stop thermostat alarm and call Authorized Uğur Service.
Turns on/off your cooler.
Mutes alarm.
For Carel Thermostat;
Manuel defrost.
Shifts to economic mode and night mode.
Temperature is increased by pressing this button after
pressing set button.
It allows setting the device temperature. It is activated
when set button is pressed for 2-3 seconds.
Temperature is decreased by pressing this button after
pressing set button.
Programming key. Only used by service personnel.
Product on/off function. Temperature is increased by
pressing this button after pressing set button simul-
taneously.
Ensures manuel defrost of the product. Temperature
is decreased by pressing this button after pressing set
button simultaneously.
It allows setting the cooler temperature. It is activated
when set button is pressed for 2-3 seconds.
47
EN