Selecting The Playback Layer; Selecting The Playback Area - Sony SCD-C2000ES Mode D'emploi

7
Press N.
Playback starts from the first track. If you
want to start playing from a specific track,
turn l AMS L (or press ./>
on the remote repeatedly) to select the track
number before pressing N.
8
Adjust the volume on the amplifier.
Basic operations during play
To
Stop play
Pause play
Resume play
after pausing
Select a track
Select a disc
Select a disc
directly
Eject a disc
Note
During playback, increase the volume level gradually
starting from the lowest level. The output from this
player may contain band width that is out of the normal
listening range. This may cause damage to the speakers
or ears.
To locate a track directly by
entering the track number
Press the numeric button(s) on the remote
to enter the track number.
To enter a track number 11 or over
1
Press >10 on the remote.
2
Enter the corresponding digits.
To enter 0, press 10/0 on the remote instead.
Example:
To play track number 30, press >10, then 3 and 10/0.
To play track number 100, press >10 twice, then 1, and
10/0 twice.
US
10
Do the following:
Press x.
Press X.
Press X or N.
Turn l AMS L (or press
./> on the remote
repeatedly).
Press DISC SKIP (or DISC SKIP
+/– on the remote) repeatedly.
Press DISC 1-5 on the player.
When using the remote, follow the
procedure below.
1
Press DISC.
2
Press the corresponding
numeric button for the disc.
3
Press ENTER.
Press A OPEN/CLOSE on the
player.

Selecting the playback layer

When playing a hybrid disc with an SA-CD
layer and a CD layer (page 5), you can select the
layer you want to listen to. Also, since both
layers are on one side, it is not necessary to turn
the disc over. The factory setting is "SEL SA–
CD" (SA-CD layer).
Press SA-CD/CD to select the desired
playback layer.
To select the default playback
layer
1
Press MENU on the player.
2
Turn l AMS L (or press ./>
on the remote repeatedly) until "LAYER
SEL" appears in the display.
3
Press l AMS L (or ENTER on the
remote).
The current default layer appears.
4
Turn l AMS L (or press ./>
on the remote) to select the desired
playback layer.
5
Press l AMS L (or ENTER on the
remote).

Selecting the playback area

When playing a disc with the 2 channel playback
area and the multi-channel playback area
(page 5), you can select the playback area you
want to listen to.
Press MULTI/2CH to select the desired
playback area.
To select the default playback
area
1
Press MENU on the player.
2
Turn l AMS L (or press ./>
on the remote repeatedly) until "M/2ch
SEL" appears in the display.
3
Press l AMS L (or ENTER on the
remote).
The current default area appears.