Items Supplied; Proper Use; Safety Information - EINHELL FKS 22/315 D Mode D'emploi

Anl FKS 22-315 D SPK1 22.09.2005
1. Layout (Fig. 1/2)
1 Saw table
2 Saw blade guard
3 Sliding table
4 Saw blade
5 Splitter
6 Parallel stop
7 Cross stop
8 Hand crank
9 Angle setting
11 ON/OFF switch
12 Clamping screw
13 Extractor hose
14 100 mm diameter extractor connection
15 Chassis
16 Push handles
17 Chip box
18 Legs
19 Table lock
23 Mounting
25 Rubber feet
28 Hook for tool
29 Mounting for extractor hose

2. Items supplied

Sizing circular saw
Carbide-tipped saw blade
Parallel stop
Push stick
Sliding table
Chassis
Cross stop

3. Proper use

The bench-type circular saw is designed for the
slitting and cross-cutting (only with the cross stop) of
all types of timber, commensurate with the machine's
size.
The machine is not to be used for cutting any type of
roundwood.
The machine is to be used only for its prescribed
purpose.
Any other use is deemed to be a case of misuse. The
user/operator and not the manufacturer will be held
liable for damage and/or injuries of any kind that
result from such misuse. The machine is to be
operated only with suitable saw blades (saw blades
made of HM or CV) It is prohibited to use any type of
HSS saw blade and cutting-off wheel. To use the
machine properly you must also observe the safety
regulations, the assembly instructions and the
operating instructions to be found in this manual.
All persons who use and service the machine have to
15:21 Uhr Seite 15
be acquainted with this manual and must be informed
about the machine's potential hazards.
It is also imperative to observe the accident
prevention regulations in force in your area.
The same applies for the general rules of
occupational health and safety.
The manufacturer shall not be liable for any changes
made to the machine nor for any damage resulting
from such changes.
Even when the machine is used as prescribed it is
still impossible to eliminate certain residual risk
factors. The following hazards may arise in
connection with the machine's construction and
design:
Contact with the saw blade in the uncovered
saw zone.
Reaching into the running saw blade (cut
injuries).
Kick-back of workpieces and parts of work-
pieces.
Saw blade fracturing.
Catapulting of faulty carbide tips from the saw
blade.
Damage to hearing if ear-muffs are not used as
necessary.
Harmful emissions of wood dust when used in
closed rooms.
4. Important information
Please read the directions for use carefully and
observe the information provided. It is important to
consult these instructions in order to acquaint
yourself with the machine, its proper use and safety
precautions.

Safety information

Warning: When using electric tools it is
imperative to take the following basic safety
precautions in order to reduce the risk of electric
shock, injury and fire.
Take due note of all this information before and
while working with the saw.
Do not lose these safety regulations.
Guard against electric shock Avoid body contact
with earthed parts.
When equipment is not being used it should be
kept in a dry, closed place out of children's
reach.
Keep mounted attachments sharp and clean to
enable you to work well and safely.
Check the power cable regularly and have it
replaced by an authorized specialist at the first
GB
15