Making A Miter Cut - RIDGID R4518 Manuel D'utilisation

OPERATION

MAKING A MITER CUT

See Figure 51.
WARNING:
Make sure the blade guard assembly is installed
and working properly to avoid possible serious
injury.
 Set the blade to the correct depth for the workpiece.
 Remove the rip fence.
 Set the miter gauge to the desired angle and tighten the
lock knob.
 Make sure the wood is clear of the blade before turning
on the saw.
 Turn the saw on.
 Let the blade build up to full speed before moving the
workpiece into the blade.
 Hold the workpiece firmly with both hands on the miter
gauge and feed the workpiece into the blade.
NOTE: The hand closest to the blade should be placed
on the miter gauge lock knob and the hand farthest from
the blade should be placed on the workpiece.
 When the cut is made, turn the saw off. Wait for the
blade to come to a complete stop before removing the
workpiece.
MAKING A BEVEL CROSS CUT
See Figures 52 - 53.
WARNING:
Make sure the blade guard assembly is installed
and working properly to avoid possible serious
injury.
WARNING:
The miter gauge must be on the right side of the
blade to avoid trapping the wood and causing
kickback. Placement of the miter gauge to the
left of the blade will result in kickback and the
risk of serious personal injury.
 Remove the rip fence.
 Unlock the bevel locking lever.
 Adjust the bevel angle to the desired setting.
 Lock the bevel locking lever.
 Set the blade to the correct depth for the workpiece.
 Set the miter gauge to 0° and tighten the lock knob.
 Make sure the wood is clear of the blade before turning
on the saw.
 Turn the saw on.
 Let the blade build up to full speed before moving the
workpiece into the blade.
BLADE
STRAIGHT
MITER GAUGE
ANGLED
VIEWED FROM THE FRONT, BELOW THE TABLE SAW
TO UNLOCK
BEVEL SCALE
BLADE
ANGLED
 Hold the workpiece firmly with both hands on the miter
gauge and feed the workpiece into the blade.
NOTE: The hand closest to the blade should be placed
on the miter gauge lock knob and the hand farthest from
the blade should be placed on the workpiece.
 When the cut is made, turn the saw off. Wait for the
blade to come to a complete stop before removing the
workpiece.
37 − English
MITER CUT
HEIGHT/BEVEL
HANDWHEEL
BEVEL LOCKING
LEVER
BEVEL CROSS CUT
MITER GAUGE
STRAIGHT
ADJUSTING
Fig. 51
TO LOCK
Fig. 52
Fig. 53