Conti Grinder200 CG-200 OD Manuel D'utilisation page 23

C. Cleaning the grinding chamber grinding parts and powder outlet housing
• Follow the instruction below for grinding chamber and grinding parts cleaning:
Step 1
By using a screw driver
take out the dial's safety
screw. Rotate the
grinding dial clock wise
to take it off.
•
Do not use sharp objects to scrape coffee residue off of the blades or the internal Teflon coating
of the outlet port.
•
Examine both of the blades' condition and replace them if necessary.
•
The replacement and assembly of a new set of blades is a delicate task.
Only skilled technical personnel should be allowed to perform blade removal.
•
If a more thorough clean is required, then the operation must be performed by skilled technician.
After all cleaning and replacing tasks are through make sure to assemble all of the parts and safety
screws the same way as they were disconnected. If anything does not fit back together or there are
some leftover parts, do not attempt to operate the appliance, call for the assistance of your engineer.
To ensure long lasting grinder and great fresh taste of coffee, the cleaning procedure,
as described above, should be repeated periodically and at least once per month or as necessary
according the grinder's usage and quality of beans.
SACOME, Document CONFIDENTIEL,
Step 2
Pull out the upper
blade holder; make
sure not to lose the
upper blade three
supporting springs.
Edition 11/2016 - CG200 OD
Ne peut être reproduit ni communiqué sans notre accord préalable.
- 21 -
Step 3
Use a brush, a dry cloth,
and a vacuum cleaner to
clean the grinding chamber
thoroughly
Step 4
Use a brush, a dry
cloth, and a vacuum
cleaner to clean the
upper and lower blade
thoroughly.