Safety Devices; Safety Instructions - Conti Grinder200 CG-200 OD Manuel D'utilisation

7. SAFETY DEVICES

A.
Thermal overload protection
In order to eliminate the risk of fire the motor is equipped with an overheat protection device which will
cut off the motor's power supply should it reach a high temperature.
•
In the event that the thermal protection is tripped as a result of malfunction (e.g.: jammed blades,
worn out bearings, foreign object in grinding chamber, etc.) the appliance main switch should be
turned off immediately and the main power plug must be disconnected. For further handling of the
device contact your local service provider, and allow the appliance to cool down before any further
maintenance.
•
In the event that the thermal protection is tripped as a result of a long continuous operation (read
section 5, for operating intervals) allow the appliance to cool down and reset the thermal cutoff
protection by unplugging the main cable from the socket. On the first operation after resetting a
tripped overheat protection device observe the grinding quality and noise level, and if there are any
irregularities shut down the appliance and call a certified technician for a complete analysis of the
appliance.
B.
Grinding chamber safety screws
The grinding chamber can be a hazardous area if the proper precautions aren't observed. The hopper
safety screw (fig.4.1) and the grinding dial safety screw (fig6.1) should never be removed during normal
operation of the appliance unless the appliance is disconnected from the power source.
C.

SAFETY INSTRUCTIONS

•
NEVER OPERATE THE GRINDER IF THE BEAN HOPPER IS NOT FULLY SECURED TO
THE TOP BLADE HOLDER. BEFORE REMOVING THE HOPPER FOR ANY REASON MAKE
SURE TO DISCONNECT THE POWER SUPPLY.
•
AVOID CLEARING FOREIGN OBJECTS FROM THEGRINDING CHAMBER OR HOPPER
WHEN THE APPLIANCE IS PLUGGED INTO A POWER SOCKET.
•
Never attempt to insert your fingers or any foreign objects into the grinding chamber or blades.
•
Be aware that grinding blades continue rotating for a short while after the grinding operation has
ended.
•
BEFORE ANY MAINTENANCE, EVEN FOR CLEANING, ALWAYS DISCONNECT THE POWER
SUPPLY.
•
In the event that the appliance has a malfunction or the blades need to be replaced, do not
attempt to service the appliance, unless you got the specific training by a certified trainer to do
so.
•
Do not change or tamper with the appliance.
•
Do not use the appliance barefoot or if your hands or feet are damp.
•
Do not use the cable wire to pull and disconnect the power plug.
•
Always keep the appliance dry (internally and externally).
•
Never re grinds grinded coffee.
•
Never attempt grinding anything else other than coffee beans.
SACOME, Document CONFIDENTIEL,
Fig.6.3
Edition 11/2016 - CG200 OD
Ne peut être reproduit ni communiqué sans notre accord préalable.
- 19 -