Conti Grinder200 CG-200 OD Manuel D'utilisation page 19

B.
Dose counting LCD:
•
The CG200 OD model is equipped with 3 independent dosing counters.
•
In order to view each one of the counters a single press on the counter selector will flip
the LCD to the next counter and the relative counter's LED will turn on.
•
2 of the counters are resettable (middle and left most LED); in order to reset each of
these 2 counters a 5 sec continues press on the counter selector will zero the
relative counter.
•
On single cup mode each coffee demand will increase the counting on all the 3 counters in 1 .
•
On double cup mode each coffee demand will increase the counting on all 3 counters in 2.
•
On continuous mode the counters are not counting.
C.
Programming grinding time for single and double cup modes:
The CG200 OD is factory set with time values for single and double dose grinding periods. These
pre set values are obviously estimated and user should find his own times according the coffee
grinding request. In general as the coarseness of grind is coarser the time required to grind
same weight of coffee is shorter. Additionally different type of coffee blends and coffee shops
are requiring different dose size for their single and double cups:
→ 6.5gr to 9.5gr per single cup
→ 11gr to 18gr for double cup
D.
Grinding time setting:
The CG200 OD is supporting the need of the user to change grinding time setting frequently. In order to
change time setting of single cup or double cup mode please follow these steps:
Press the desired mode selector button continuously for longer than 3 sec.
1.
When in programming mode the mode selector's LED is blinking.
Watch the LCD display is now showing your current set up time (in seconds and tents of
2.
seconds).
In order to increase or decrease set up time simply rotate the peripheral scale of the knob
3.
and watch the time set up on the LCD is changing up or down according direction of
rotation.
When reaching the desired time value press shortly the mode selector button to return to
4.
normal working mode (watch the display is returning to counter mode).
E.
Adjusting coffee grind :
The grinding blades' distance was factory pre adjusted to satisfy different common coffee grinds (from
super fine to coarse) corresponding gap distance from 0.05mm to 0.5mm.
→ Turning the grinding dial incrementally counterclockwise will make the grind finer
→ Turning it clockwise will make the grind coarser.
Grind a small amount of coffee and test its coarseness with your espresso machine.
As coffee beans' qualities and characteristics are changing from time to time, it is recommended
repeating this adjustment once in a while.
SACOME, Document CONFIDENTIEL,
Edition 11/2016 - CG200 OD
Ne peut être reproduit ni communiqué sans notre accord préalable.
- 17 -