Correct Disposal Of This Product; Service And Repair - Steba LB 7 Mode D'emploi

remover should be used or fill vinegar in the bassin. After some time, depending on deposit,
the scale dissolved. After this the base must be cleaned completely with clean water. The fil-
ter should be put into salty water (1 spoon salt per litre) for one day for recovery. Then rinse
the filter with clear water and shake it and then let it dry.
∙ Steba tipp: Weekly cleaning avoids white sediments. Bacteria and germs will not
have a chance! When the device is regularly used, its cleaning will be easier and
quicker.
∙ Carefully clean the ultrasonic membrane at the bottom part with a brush. Scale
reduces the atomization. Reassemble the appliance and store in a dry place up till
next usage.

Correct Disposal of this product

This marking indicates that this product should not be disposed with other household
wastes throughout the EU. To prevent possible harm to the environment or human
health from uncontrolled waste disposal, recycle it responsibly to promote the sustaina-
ble reuse of material resources. To return your used device, please use the return and
collection systems or contact the retailer where the product was purchased. They can take this
product for environmental safe recycling.
Packaging disposal: Do not throw away the package materials. Please put it in the recycling
bin.
Gift box: Paper, should be put to the old paper collection point. Plastic
packaging material and foils should be collected in the special collection
containers.

Service and Repair:

If the appliance must be repaired, please get in touch with your trader or with the manufactu-
rer:
e-Mail: elektro@steba.com Internet: http://www.steba.com
Troubleshooting
Failure
Power light works not
Light is on but no mist
Smell
Light is off, the appli-
ance does not work
14
STEBA Elektrogeräte GmbH & Co KG
Pointstr. 2, 96129 Strullendorf / Germany
Distribution-Tel.: 09543 / 449-17 / -18,
Service-Tel.: 09543 / 449-44, Fax: 09543 / 449-19
Possible Reason
No Power
No water in tank
The safety switch is
not released
Smells like a new
device
Dirty or old water
Too much water in the
water tank
Solution
Please check if the unit is plugged in and
the power button is pressed.
Fill water in the tank.
Check if the water tank is attached cor-
rectly.
Clean the tank and the base completely
and let it dry open at least 2 hours