99641522_A_ML2.qxp
EN
2 / USING YOUR APPLIANCE
• •
USING THE PROGRAMMER
• How to set the time
- -
When plugged in
The displays flashes 12:00 (fig.1).
Set the time by pressing the + or - buttons
(holding your finger on the button allows you
to scroll through the numbers rapidly) (fig.2).
Example: 12:30
Press the
button to confirm.
The display stops flashing (fig.3).
- To set the time on the clock
Press and hold the "
seconds until the display is flashing (fig.1),
then release.
Audible beeps indicate that it is now possible
to set the time.
Adjust the clock setting with the + and -
buttons (fig.2).
Press the
button to confirm.
Warning
If there is no confirmation from the
"
" button, the time is recorded
automatically after a few seconds.
14/05/2007
10:03
Page 96
" button for a few
96
fig.1
fig.2
fig.3
fig.1
fig.2