Installing The Main And Additional Monitors - Philips WelcomeEye Connect Guide D'installation

3. Installing the main and additional monitors

1
4
7
1 - Place the wall bracket so that the monitor screen is at a height of around 1.60 m off the
ground.
2 - Locate where to drill the holes using the mounting bracket.
3 - Drill.
4 - Insert the plugs adapted to the bracket (the plugs provided are suitable for solid walls).
5 - Attach the wall bracket.
6 - Connect the 2 intercom panel wires and the 2 power supply wires, paying close attention
to the wiring diagram.
7. Position the monitor on the wall bracket.
8 - When the wiring has been installed, you may need to configure the interface depending
on the chosen configuration. For more information, refer to the complete instructions
downloadable at www.philips.com.
Warning: during this step, do not connect the power supply to the 230V AC
GB7
1m60
2
5
WelcomeEye Connect / Touch / 08/17
3
DES 9900 VDP
Wi 2.4GHz 5 3 8 1 0 2
24V 550mA
+ -
1/3 2/4
CFI Extel
ZI de Fétan, 01600 Trévoux
FRANCE
DES 9900 VDP
5 3 8 1 0 2
6