Information For Operation - Weller WSP 80 Manuel D'utilisation

1. Description
The Weller micro-solderer WSP 80 features precise and quick heating to the required solder
temperature. An excellent dynamic behaviour is achieved using an especially powerful 80W
heater element. Together with the slimline form and the simple change of soldering bits, this
soldering iron can be universally used in all situations from extremely delicate soldering to
those where there is a greater temperature requirement.
With an integrated grounding connector, there is the possibility for a grounding of the solder
bit if required. The anti-static handle and cables mean that the soldering iron satisfies all
requirements of the EGB safety.
Specifications
Connecting voltage: 24V
Power: 80 W
Warm up time: approx. 10 sec. (50°C - 350 °C)
Max. temperature: 450 °C
Connectable to: all 80 W power units
2. Installation
Place the soldering iron in the safety holder. Remove all flammable articles from around the
soldering iron. Plug and lock the connector (7) into the supply unit. Set the required temperature
on the supply unit. Wet the soldering bit with solder once it has heated up.
3. Grounding
If required, an grounding of the soldering bit can be created via the supply unit. The connection
possibilities for grounding are described in the instructions for the supply unit.
WSP_80_05.01 5

4. Information for Operation

GB
Changing soldering bits
- hold soldering iron horizontal.
- loosen the knurled nut around the bit-sleeve (2).
- pull the bit-sleeve (2) towards the front.
- the soldering bit now sits loosely in the sleeve.
Warning: Soldering bit is HOT!
Do not place the hot soldering tip on the cleaning sponge or on plastic surfaces.
When using a number of different solder bits, it is recommended that the soldering bit and
sleeve are used together as a quick change system.
Keep the heating element and solderin tip heat transfer surfaces clean.
Anti-static plastics containing conducting fillers are used to prevent static charge build-up.
This also means that the insulating properties of the plastic are reduced. No work should be
undertaken on articles which are live, or at high voltage.
The instructions for the use of the supply unit are valid in addition to these here.
5. Accessories
Soldering bits figure LT-Tips see pages 6 - 8.
03.06.2002, 8:36 Uhr
5