Publicité
13
O
Place Flush Valve Angle Stop Cap (S) on Flush Valve Angle Stop (O).
Coloque la tapa de la llave de paso angular de la válvula de descarga
(S) en la llave de paso angular de la válvula de descarga (O).
Placer le capuchon du robinet d'arrêt d'équerre du robinet de chasse
(S) sur le robinet d'arrêt d'équerre du robinet de chasse (O).
Flow rate change steps
Pasos para combiar el
flujo volumétrico
Étapes de modification
du débit
Note: Shut off water and then activate handle before continuing. If
different flow volume is desired, use different Replacement Piston
and Exterior Cap service kits in steps 4 and 5. See "Illustrated Parts"
for service kits.
Nota: Cierre el agua y luego active el monomando antes de continuar.
If different flow volume is desired, use different Replacement Piston
and Exterior Cap service kits in steps 4 and 5. See "Illustrated Parts"
for service kits.
Remarque : Fermer l'alimentation en eau, puis activer la poignée
avant de continuer.
If different flow volume is desired, use different
Replacement Piston and Exterior Cap service kits in steps 4 and 5. See
"Illustrated Parts" for service kits.
S
Installation complete.
La instalación está completa.
Installation terminée.
1
5/64"
5/64"
5/64 po
O
1.
Using a 5/64" hex wrench (not included), loosen and remove
Set Screw (B).
2.
Lift and set aside Exterior Cap (A).
2
2
A
R
1.
2.
5
INS10150B - 8/16
P
1
2
R
Using a 3/8" hex wrench (not included), loosen Interior Cap (P).
Remove and set aside Interior Cap..
3/8"
3/8"
3/8 po
Publicité
