Panasonic TY-ST85PF12 Manuel D'installation page 10

2) Align the hole position of grounding plate 
with the grounding plate screw  mounted
during Step 1, then put on grounding plate  .
3) Push the grounding plate  mounted in Step
2 toward the plasma display side, and align the
hole positions with the display mounting fixture
 .
※ Make contact between the gasket on the
front of the grounding plate and the plasma
display.
4) Insert the grounding plate screws  in the
numeric order shown in the illustration.
(5 is the loosely inserted screw from Step 1.
Insert so that the washer does not get wedged
in.)
Assemble the right side the same way.
•
The screws should be securely tightened to
the torque given below.
(1.2~1.5 N•m)
5) Using 4 grounding plate screws  , mount
grounding plate (small)  to display mounting
fixture  and supports  .
Assemble the right side the same way.
•
The screws should be securely tightened to
the torque given below.
(1.2~1.5 N•m)
Gasket
5
4
3
2
1
Gasket
Grounding plates (small) 
Grounding plate screws 
5
4
3
Rear
2
1
21