Panasonic TY-ST85PF12 Manuel D'installation page 6

Assembly
Never use any other method than specified to install.
1. Preparation of supports (one each on left and right)
The weight of the Floor stand is approximately 82 kg (180.8 lbs.).
For the weight of the plasma display attached to the Floor stand, please see manual for the plasma display.
The plasma display can be set at any of three installation heights: 100 cm (39.4 inches), 90 cm (35.5 inches) or
80 cm (31.5 inches).
The installation height is the height from the floor to the bottom of the plasma display. Assemble by aligning with the
appropriate stamped marks.
Stamped marks1:
100 cm (39.4 inches)
1. Join display mounting fixture  to
support  using 2 display mounting
fixture hexagon bolts  and 2 flanged
cap nuts  .
Assemble so that the flanged cap nut
 is on the side of support  facing
outside.
Assemble the other side the same way.
•
The bolt should be securely tightened to
the torque given below.
(12~14 N•m)
Stamped marks2:
90 cm (35.5 inches)
Display mounting fixtures 
Left
Display mounting
Flanged cap nuts 
fixture hexagon bolt
(with washers) 
Stamped marks3:
80 cm (31.5 inches)
Right
Flanged cap nuts 
Supports 
17