Washing Instructions - CASUALPLAY beat FIX Mode D'emploi

Installation of the Beat Fix seat facing forwards with three-point seat belt (car seat belt) (see
illustrations 36 - 38)
WARNING: NEVER USE THE ISOFIX SYSTEM ON GROUP 2. DO NOT SECURE THE CHILD
WITH THE SEAT HARNESS. ALWAYS USE THE THREE-POINT SEAT BELT OF THE CAR.
ALWAYS USE THE SEAT IN ITS LOWEST RECLINING POSITION.
• Pass the buckle through the slot in the crotch strap. Fit the upper parts so it does not get lost and
make sure that it is hidden under the frame.
• Place the seat on the vehicle seat pressing it firmly against the backrest.
• Position the child in the seat and fasten him in with the three-point seat belt of the vehicle. Check
that the abdominal part is as low as possible and that the diagonal part secures the child's thorax
(fig. 36).
• Fasten the buckle passing the male part through the side opening of the frame (fig. 37). Next, pull
the chest part passing it through the upper belt guides of the seat (fig. 38).
Removing the upholstery (According to model. See diagrams 39 - 41)
• Remove the harness following the instructions in the corresponding section.
• Remove the headrest. Undo the nut on the back of the headrest (fig.39), then use the height
adjustment handle to raise the headrest until it comes off (fig.40). Remove it.
• Take the elastic strips off that hold the upholstery to the frame. These strips are situated on the
sides of the lower part of the frame.
• Pass the harness straps through the openings in the upholstery and take the upholstery off
(fig.41).
• Follow the same steps in reverse order to fit the upholstery.
Removing the upholstery (According to model. See diagram 42)
• Loosen the harness by pressing the rear part of the TMS downwards and pulling the chest straps
underneath the protectors with the other hand.
• Release the clasps on the backrest (fig.42).
• Release the elastic bands on both sides situated underneath the frame.
• Remove the upholstery.
• Follow the same steps in reverse order to fit the upholstery.
NOTE: Never take out the interior protection in the absorbent material.

Washing instructions

• Machine wash the cover at a maximum temperature of 30ºC and without spinning. The painted
parts should be cleaned using a non-abrasive polish that does not contain solvents.
22