CASUALPLAY beat FIX Mode D'emploi page 23

Fitting the seat straps (harness)
• Fasten the buckle (fig. 28).
• Tighten the shoulder straps pulling the end of the harness adjustment strap until it fits correctly,
taking care to always leave some room for movement.
• To loosen the seat straps, press the TMS forwards and pull the shoulder straps with the other
hand.
IMPORTANT: Make sure that the straps of the seat are not twisted when the child is using it. It is
very important to make sure that the abdominal belt is positioned as low as possible so the pelvis
is firmly secured.
Changing position (see illustrations 26 - 27)
• The position of the seat can be changed easily with just one hand by pressing the lever situated
on the front part of it (fig. 26 - 27).
IMPORTANT: Make sure that the seat is not in-between two positions, a click will indicate that it is
in the right position.
Closing the fastening buckle (see illustration 28)
• To fasten the harness buckle of the seat put the two parts together and insert them into the female
part with the red button, pressing until it clicks (fig. 28).
• Press the red button to open it.
• Check that the straps are not twisted.
Removing the harness (diagrams 29 - 35)
• Loosen the harness by pressing the rear part of the TMS downwards and pulling the chest straps
underneath the protectors with the other hand (fig.29).
• Take the two ends of the harness out of the distribution bar (Fig.30), situated on the lower part of
the frame. Then pass the harness through the slots on the frame and the headrest.
• Take the plastic clips off the chest protectors (fig.31), on the back of the frame, and pass the
straps through the slots (fig.32).
• Remove the protectors (fig.33).
• Pass the strap through the flap in the buckle (fig.34)
• Conceal the buckle under the upholstery.
• Remove the elastic strips that fasten the upholstery onto the frame and the abdominal protectors.
These strips are situated on the sides on the lower part of the frame. Take the protectors of the
strap (according to model).
• Lift the upholstery up, find the clips and pass the strap through the slots. The clips are on both
sides of the lower part of the frame.
• Follow the steps in reverse order to fit the harness, taking care that the straps are not twisted
(fig.35). The inner plastic strip of the abdominal protectors should stay on the inside, first fasten
the elastic bands of the protector and then those of the upholstery.
GROUP 2 (15 - 25 KG.)
21