Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7.
Adjust the arm length
1.
Loosen the screw on the arm (
2.
Adjust the length of the arm using the measure on the bottom to match the projection distance
recommended in "Positioning the Projector" on page 14 (
3.
After adjusting the length, secure the arm position temporarily by tightening the screw on
top (
).
8.
Attach the interface cover bracket
Attach the interface cover bracket using the hexagonal wrench (M4) and two M4 × 12 mm bolts with
washers.
M4 × 12 mm hexagon
socket head cap bolt
with washer (×2)
Interface cover bracket
).
30
).
Publicité
Table des Matières
