Publicité
Les langues disponibles
Les langues disponibles
Do not overload the machine by pressing with excessive force! The best
sanding results are achieved with moderate press-on pressure.
The flexibly mounted grinding head enables to the sander to best match the
grinding surface. However, please take care not to stretch the flexible drive
shaft excessively.
!
Attention!
Do not touch rotating parts!
Overload Protection
In order to protect the user, the motor and the tool is equipped with an
electronic overload protection.
Electronic:
In case of overload caused by a grinding pressure
which is too high, the
the machine.
you can continue working after switching OFF and ON the
power tool again.
Thermal:
In case of permanent overload, a thermal sensor protects
the motor against destruction. In this case, the tool
switches off automatically and can only be restarted after a
certain cooling period (approx. 2 minutes). Actuate the
ON/OFF switch! The cooling period depends on the
heating of the motor winding and the ambient temperature.
Care and Maintenance
Before the beginning of the maintenance or repair works you
have to disconnect the plug from the mains.
Repairs may be executed only by appropriately qualified and experienced
personnel.
After every repair the machine has to be inspected by an
electric specialist. Due to its design, the machine needs a minimum of care
and maintenance. However, the following points have to be observed:
Always keep the power tool and the ventilation slots clean.
During work, please pay attention that no particles get inside the
machine.
In case of failure, a repair has to be carried out by an authorised
service workshop.
Replacing the flexible drive shaft:
If necessary, you can easily replace the flexible drive shaft (see Fig. 1).
To do so, press in one of the two locking pins with a suitable tool (for
example a screwdriver) and at the same time pull the shaft together with
the protective hose from its holder. With the locking pin depressed, insert
electronics react by switching OF
After automatic switch-OFF of the machine
22
Publicité
