ergoCentric upCentric Guide De L'utilisateur page 8

Step 3:
Place Cross Bar Pieces
against either side of the Leg
and secure with Small Bolts
Step 4:
Insert Bracket
and secure with Larger Bolts
( PART Q )
. Once these pieces are assembled, this
F )
entire part becomes
Step 5:
Open the larger box and remove all contents.
Step 6:
Separate the left and right side of the Frame
and
R1 ) ( PART R2 )
then by sliding each end of the frame in opposite directions until the two
Inner Cross Beam Bars are completely removed from
attached to
( PART R2 )
8
( PART I )
( PART Q )
( PART F ) .
into end of
( PART M )
( PART T ) ( BELOW )
Part T
by first CAREFULLY removing the wires from wire clips and
.
R1
I
( PART
M
.
Q
Q
making
( PART R )
and only
( PART R1 )
R2
I
( PART