ergoCentric upCentric Guide De L'utilisateur page 10

Step 10B:
Run cords from all three legs to the Control Box. For the
Extended Leg, run the cord between the tabletop and the frame through
the small Inlet Hole and the clip cords into the Wire Clips
( SHOWN WITH
to stop the wire from hanging out. Do not connect cords to
CIRCLES )
control box.
Note:
For ideal
positioning, the table
top should extend past
the frame by 2"-6" when
possible.
Add Plugs into
Step 11:
( PART O )
holes on each side of the frame.
10